如何避免弱電干擾?
1.強弱電要分開走線，禁止共管共盒，且強弱電之間線路的平行距不得小於30cm。
2.不同弱電線要分開穿管，不可共用同一條管，否則會造成信號干擾。
3.布線施工時，先安裝管路再穿線，方便日後進行維護和換線。
4.千萬不能有導線把管內空間塞滿的情況，一般彎管的利用率在40%-50%左右，直線管的利用率在50%-60%左右。
5.若線路需轉彎，千萬不能出現折斷式的轉直角，不僅造成導線無法穿過，還會影響信號強度。
* * * * * *
創世服務有限公司是一間提供專業數據中心架設公司，擁有一群專業團隊貼心地關注客戶的要求，並提供優質的服務。
想了解更多關於「 為何強弱電要分開?」的內容，請瀏覽創世官網：http://livservices.com.hk
地址: 香港觀塘鴻圖道37-39號鴻泰工業大廈4樓4室
電話：852-31063235
——————
Why do you want to separate strong and weak electricity?
There is no common slot between strong and weak power, otherwise it will interfere with the transmission of weak electricity information, affect the normal use of the equipment, and even lead to a fire house.
How to avoid weak electrical interference?
1. Strong and weak electricity should be separated and routed together. It is forbidden to share the common box, and the parallel distance between the strong and weak electricity lines should not be less than 30cm.
2. Different weak wires should be piped separately. Do not share the same pipe, otherwise it will cause signal interference.
3. When wiring construction, first install the pipeline and then thread the thread to facilitate maintenance and change of line in the future.
4. Do not have the wire to fill the inner space of the pipe. Generally, the utilization rate of the pipe is about 40%-50%, and the utilization rate of the straight pipe is about 50%-60%.
5. If the line needs to turn, it must not have a broken right angle, which not only causes the wire to pass through, but also affects the signal strength.
* * * * * *
LIV is a professional data center to set up a company, with a group of professional team intimate attention to customer requirements, and provide quality services.
For more information about 'Why do you want to separate strong and weak electricity?'，please visit : http://livservices.com.hk
Address: Unit 4, 4/F., Hung Tai Industrial Building,37-39 Hung To Road, Kwun Tong, Hong Kong
Tel: +852 3106 3235
联系我时，请说是在季晨网看到的，谢谢！
